Last updated: May 2, 2026
Rigid Foam in Bonita, CA.
Rigid Foam for Bonita homes, done by licensed San Diego County technicians. Rigid foam handles thermal bridging — the heat that bleeds through studs and rafters. We install EPS, XPS, or polyiso continuous insulation on exterior walls, under flat or low-slope roofs, on the underside of slabs, and as a thermal break under siding.
Why is rigid foam different in South County San Diego?
South County rigid foam is mostly new-construction and ADU work — continuous insulation on exterior walls and slab edges in EastLake and Otay Ranch builds.
What's included in rigid foam in Bonita?
- EPS, XPS, and polyiso board installation
- Continuous exterior insulation under siding
- Under-slab and slab-edge rigid foam
- Roof deck insulation for unvented assemblies
- Tape and seal seams for vapor and air control
- Furring strip layout for siding restoration
- Coordinate with siding, roofing, and concrete trades
When does a Bonita home need rigid foam?
- Siding redo — add continuous insulation in the same scope
- Low-slope roof rebuild
- Cold floors over slab in inland or East County homes
- Conditioned attic conversion with unvented roof deck
- Title 24 alteration that requires continuous insulation
What do Bonita homeowners ask about rigid foam?
How fast can you get to Bonita for rigid foam?
Same-day service in Bonita on most weekdays. Morning slots book fastest during heat waves — call before 10 a.m. for best-same-day availability. After-hours emergency calls are answered by an on-call technician, not a dispatcher.
What does rigid foam cost in Bonita?
$2.50–$6 per sq ft installed depending on board and assembly. Pricing is the same across San Diego County — no mileage upcharge for Bonita. Our $89 diagnostic is credited toward the repair if you move forward.
How does Bonita's climate affect this service?
Bonita sits in a mixed zone — coastal-influenced west, inland-influenced east. Older homes usually need attic top-ups to R-38 or R-49; newer EastLake and Otay Ranch builds are code-compliant and may only need spot work or air-sealing.. South County rigid foam is mostly new-construction and ADU work — continuous insulation on exterior walls and slab edges in EastLake and Otay Ranch builds..
EPS, XPS, or polyiso — which board?
EPS is cheapest and vapor-permeable; good for exterior walls and below grade. XPS has higher R per inch and resists moisture; common on roofs and under slabs. Polyiso has the highest R per inch but loses some R in cold weather — fine in San Diego where it rarely gets that cold. We pick based on assembly and budget.
Will adding rigid foam mess up my windows and doors?
It pushes the wall plane out. We extend window and door jambs with proper trim, flash to drainage planes, and detail water management. This is normal exterior-insulation work and we plan for it on the quote.
Need rigid foam in Bonita?
Call for a free quote. Same-day service on most repairs, next-day on most installs.