Last updated: May 2, 2026
Rigid Foam in Campo, CA.
Rigid Foam for Campo homes, done by licensed San Diego County technicians. Rigid foam handles thermal bridging — the heat that bleeds through studs and rafters. We install EPS, XPS, or polyiso continuous insulation on exterior walls, under flat or low-slope roofs, on the underside of slabs, and as a thermal break under siding.
Why is rigid foam different in Backcountry San Diego?
Backcountry rigid foam handles freeze-thaw exposure and adds thermal mass. We use it on under-slab and slab-edge applications in Julian and Pine Valley cabin construction.
What's included in rigid foam in Campo?
- EPS, XPS, and polyiso board installation
- Continuous exterior insulation under siding
- Under-slab and slab-edge rigid foam
- Roof deck insulation for unvented assemblies
- Tape and seal seams for vapor and air control
- Furring strip layout for siding restoration
- Coordinate with siding, roofing, and concrete trades
When does a Campo home need rigid foam?
- Siding redo — add continuous insulation in the same scope
- Low-slope roof rebuild
- Cold floors over slab in inland or East County homes
- Conditioned attic conversion with unvented roof deck
- Title 24 alteration that requires continuous insulation
What do Campo homeowners ask about rigid foam?
How fast can you get to Campo for rigid foam?
Same-day service in Campo on most weekdays. Morning slots book fastest during heat waves — call before 10 a.m. for best-same-day availability. After-hours emergency calls are answered by an on-call technician, not a dispatcher.
What does rigid foam cost in Campo?
$2.50–$6 per sq ft installed depending on board and assembly. Pricing is the same across San Diego County — no mileage upcharge for Campo. Our $89 diagnostic is credited toward the repair if you move forward.
How does Campo's climate affect this service?
Campo sees real winters along with hot summers. We push to R-49 minimum in attics, pay close attention to crawl space rim joists for freeze protection, and use mineral wool on exterior assemblies that see freeze-thaw cycles.. Backcountry rigid foam handles freeze-thaw exposure and adds thermal mass.
EPS, XPS, or polyiso — which board?
EPS is cheapest and vapor-permeable; good for exterior walls and below grade. XPS has higher R per inch and resists moisture; common on roofs and under slabs. Polyiso has the highest R per inch but loses some R in cold weather — fine in San Diego where it rarely gets that cold. We pick based on assembly and budget.
Will adding rigid foam mess up my windows and doors?
It pushes the wall plane out. We extend window and door jambs with proper trim, flash to drainage planes, and detail water management. This is normal exterior-insulation work and we plan for it on the quote.
Need rigid foam in Campo?
Call for a free quote. Same-day service on most repairs, next-day on most installs.